Tilt door
Model « B2018 ECO »

The Frame :

It is made of two brackets and a top crosstie.
Every bracket includes the vertical rail and one of the balancing counterweights.
The suspension systems are made with 08B1 steel chains, break resistance 180kg.
They are the link between the counterweights and the bottom part of the door leaf.
The main axis, which receives the bevel gears, is set on six AA bearings, allowing a good distribution of the strengths.

The Door Leaf:

It is made of a machine-welded steel frame reinforced by one or several middle crossties.

All of it is made with rectangular tubes from different sections, depending on the dimensions of the door leaf.

The casing of the door leaf is made with ribbed steel sheet installed vertically or horizontally, pre-lacquered with the color RAL 9002, or on demand:

With flat steel sheet, thickness 15 or 20/10th
With hollow joint coffers
With wood (variety to decide)
With bars
Diamond-shaped

Weight of the frame and casing together limited to 90kg.
The limit size of the door leaf is 10m2 with a maximum passing height of 2400mm.
The bottom guide rollers are set on the link pins located between the chain and the door leaf.
The top guide rollers are made with self-lubricating material and guided by V-shaped rails, holding the door leaf centered throughout the whole process.
CE conformity following the EN 13241-1 norm.

The Motorization:

It is ensured by a differential gear motor attached to the center of the top crosstie.
The motion of the door leaf is provided simultaneously by a trolley that is picked up in the center of the middle part of the panel and by the motorization of the bevel gears lifting the door leaf by its bottom part.
The closing locking is provided by the trolley, which demands little effort from the mechanics and results in a strong blocking.
The limitation of efforts and speed are ensured by the inner electronics of the motor. The latter allows a quiet functioning with a progressive acceleration and deceleration to avoid any jolt.
This motorization is made for extensive use.

The Automation:

An « MCE 4 » control cabinet ensures :

The recording of the inside and outside opening orders
The automatic closing once the vehicle has gone through the door
The power supply for the permanent lighting
The power supply for the pre-signaling
The parking timer switch
The alarm or tele surveillance forwarding
The engine operation delay
The maximal opening time
The control of the securities and end positions
On demand, we can include the management of the traffic lights

The Security:

It is ensured by:

A flexible section in the bottom part of the door leaf, compression 50mm.
Two outside cell detectors placed 15 and 40cm from the floor for presence detection and to control the vehicles going in and out.
The manual start is automatic if the end position is not reached or in the event of an emergency stop or lack of tension.
A detection system for unusual force used on the panel.

La Signalisation :